News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Digi

Pages1
#1
Knife Sharpening / Re: Buck Strider 881 mini tanto convex regrind
December 01, 2023, 02:14:49 PM
very good result, I think the finish is much better than before  :)
#2
Knife Sharpening / Re: Sharpening knives, grinding into or trailing?
November 27, 2023, 07:25:53 AM
I am also in the mixed group :) .
I am still a beginner in the field of sharpening and I sometimes find it a challenge to grind a nice even cutting edge with the jig.
Until now I also do free hand honing, but I ordered the FVB and will experiment with it soon.
#3
Knife Sharpening / Re: MB -102 multibase honing angle T4
November 16, 2023, 03:59:06 PM

Hello thank you very much for the info! I think this will indeed solve my problem.I will definitely try the calculator and measure the distance from top USB to the top of the wheel, thanks!
Greetings Dietger[/quote]

#4
Knife Sharpening / MB -102 multibase honing angle T4
November 16, 2023, 11:01:03 AM
Hello i am new here from Belgium

I have a tormek T4 that I bought to sharpen knives and I would like to do supportive honing and would buy the MB-102 support for that. Now I'm wondering how to determine the angle on the small honing wheel which is diameter 145mm and the tormek WM-200 angle setter only goes down to diameter 150mm.
Greetings Dietger
Pages1