News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Digi

#1
Knife Sharpening / MB -102 multibase honing angle T4
November 16, 2023, 11:01:03 AM
Hello i am new here from Belgium

I have a tormek T4 that I bought to sharpen knives and I would like to do supportive honing and would buy the MB-102 support for that. Now I'm wondering how to determine the angle on the small honing wheel which is diameter 145mm and the tormek WM-200 angle setter only goes down to diameter 150mm.
Greetings Dietger