Messages

90 degrees from the round stock you have welded on the collar . I was thinking of doing a rectangle stock 12mm x 45mm parallel to the knife edge.

After looking at the pivot pin collars that RickKrung made I started thinking. What if you put a 12mm wide flat bar to hold the knife flat against the stone to prevent swale by holding the edge perfectly flat against the stone. The round stock would still allow you to rotate to sharpen the curved end.  Is there a draw back that I am missing before trying to make some of these?

Thank you as that was exactly what I needed!

I tried to order them from knife grinders but it was rejected . I will look for the measurements to build a set. I seen he had an app for the buffer and tormek that are now unavailable is there any other apps that would allow the measurements to be put in?

Hello I am new to the forums so forgive me if this isn't allowed. I am looking for stand supports to mount in front of low speed grinders for finishing the blade after grinding. I want them to accept the Tormek US-430 support so I can move straight from the Tormek to them as I was following the build from knife grinders but am now unable to buy the stands. I have alot of money tied up in this system so I cant just abandon it. Also been searching for the pivot jigs for sale. Thank you for any help.