News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jspill

#1
Thank you for taking the time to answer my question. I found out just what I needed to know.
#2
I'm sorry I made a mistake in naming the wheel I'm interested in. It is the Sun Tiger not Sun King wheel. It is produced by the Matsumaga company. I have heard that older Tormek machines were equipped with this wheel.
#3
I have the chance to pick up a 4000 grit  Sun King wheel. I have no problem with the wheel that came with my used Tormek T7. I'm just wondering if it would be an upgrade to switch to the Sun King wheel. Thanks.
#4
Thank you for the replies. I learned a lot from watching the video on how to sharpen a chisel. Since I have a lot of practice flattening backs on water stones I think I will continue to use that method.
Ken, thank you for recommending Leonard Lee's book. I bought it several years ago and it is excellent. Recently, I met Robin Lee at the opening of the new Lee Valley store in Niagara Falls Ontario. I told him I learned sharpening from reading his dad's book. Robin went on to explain how working with and learning from his father has made Lee Valley the successful company they are today. In my experience I have never heard a single complaint about Lee Valley's customer service.
#5
I recently purchased a used T7 machine. I have never used a Tormek. Previously I have sharpened chisels and plane blades using waterstones, sandpaper, and a Worksharp. It is now time to enter the wonderful world of Tormek that I have read so much about.
I need to sharpen set of chisels for a Record #44 plow plane. First I want to flatten the back of each chisel. I'd like to know the proper procedure for flattening the back of a chisel or plane blade. Is the grit on the side of the wheel the only grit I need to use? Roughly how long does the blade need to be held against the wheel? Since I am brand new to this I would appreciate any advice I can be given. Thanks.