Messages

Hi Ken
That is the effect I got. but I'd prefer if they were dead straight.  They cut fine, better then ever actually.
When I get a chance I'll regrind them with less pressure, as Jeff suggested.

Thanks for the reply.
I had the stops set so that about 3/8" remained on the stone at either end.
It is more likely the pressure.
I will try again and let every one know the result.


RALPH

Hi
Just finished sharpening my 4" jointer blades using the planer blade jig.
They came out razor sharp, but they are arced.
If you place the cutting edge against a straight edge, both ends don't touch until you come in about 3/8 of an inch.
I followed the steps in the instructions exactly.
why is this happening.
Thanks in advance for your help


Ralph

Hello again.
Got the T7 today.
very well packaged.
I began sharpening my Buck knife, very simple very easy, VERY VERY sharp.
Sharpened all the kitchen knives, unbelievable how sharp they came out,
I hope the rest of the jigs work as well as the 2 knife jigs work
Tomorrow I will try the scissor jig.

More later.
RALPH

Hello all
I'm suppose to get my new T7 Ultimate package tomorrow.
I'v been reading as much as I can here on your forum, hoping to take the steepness out of the learning curve.
I'm very sure I'll be asking a lot of questions in the future.
I'm very glad you have, what seems to be, an invaluable resource here.

RALPH