Hi
Just finished sharpening my 4" jointer blades using the planer blade jig.
They came out razor sharp, but they are arced.
If you place the cutting edge against a straight edge, both ends don't touch until you come in about 3/8 of an inch.
I followed the steps in the instructions exactly.
why is this happening.
Thanks in advance for your help
Ralph
Just finished sharpening my 4" jointer blades using the planer blade jig.
They came out razor sharp, but they are arced.
If you place the cutting edge against a straight edge, both ends don't touch until you come in about 3/8 of an inch.
I followed the steps in the instructions exactly.
why is this happening.
Thanks in advance for your help
Ralph