Hello Everyone,
- Make sure the stone is true and soaked, let the machine run until the water in the tray remains at the same level if the wheel was completely dry.
- Lower the tray so the stone will not be touched by water.
- Dress/grade your stone, the dressing is much faster as the stone particles will help the process.
- Put your tool on the stone and grind/sharpen. There is enough water on the stone without being in permanent contact with it. The best stone product, the slurry, remains on the stone and helps the process.
- Use your common sense and don't let the water disappear completely from the stone, after a minute or so of grinding lift the tray enough to have the stone flushed and then lower it back.
- Repeat the process if needed until your grinding/sharpening is done. For touch-ups the process is very fast, you don't need to wait a minute.
Good luck and al the best,
Ionut
- Make sure the stone is true and soaked, let the machine run until the water in the tray remains at the same level if the wheel was completely dry.
- Lower the tray so the stone will not be touched by water.
- Dress/grade your stone, the dressing is much faster as the stone particles will help the process.
- Put your tool on the stone and grind/sharpen. There is enough water on the stone without being in permanent contact with it. The best stone product, the slurry, remains on the stone and helps the process.
- Use your common sense and don't let the water disappear completely from the stone, after a minute or so of grinding lift the tray enough to have the stone flushed and then lower it back.
- Repeat the process if needed until your grinding/sharpening is done. For touch-ups the process is very fast, you don't need to wait a minute.
Good luck and al the best,
Ionut