News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Roughing Gouge Grind

Started by edward, September 30, 2023, 09:56:32 PM

Previous topic - Next topic

edward

I had a roughing gouge that was working pretty good and I decided to sharpen it with the tormek t4.  I followed the marker method to sharpen. Now the gouge will not cut into the wood.  I have checked and even used the  settings P=75mm, SVS-50 open face and set the Universal Support with Hole A still the same result. 

I can't figure what I've done wrong.

Any help appreciated.

RichColvin

#1
On the SVS-50, I use 0° & projection of 55mm, combined with setting the USB using hole A on the TTS-100.  This gives a 35° edge angle.

https://sharpeninghandbook.info/WW-SpindleRoughingGouge.html
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.