KJ-140 middle gap normal?

[Kenshiro_Joestar]

Hello everyone,
I ordered a KJ-140 jig for grinding thin, wobbly blades (like from carpet cutting knives) and when I received it today, it is curved and the gap in the middle is 1,4 mm wide.
Can someone please tell me if this is intentional or did I receive a faulty product?
Greetings
Eric

[RichColvin]

Eric,

I have the predecessor products (the SVM-100 and SVM-140).  Both of them are the same way.  

When I use them, the ends "flex" out so that there is a consistent edge against the blade.

Rich

[Ken S]

Eric,

I agree with Rich. With traditional hand woodwork, glue ups for tabletops are usually "sprung". This means being planed so that the two ends of the board protrude ever so slightly beyond the middle of the board. When the boards are clamped together, the middle is compressed enough to be together and the ends are under pressure.

This is notquite the same as the knife jig jaws; however, extra pressure on the ends of the jaws will make the clamp more secure.

Ken 

PStoTormek: This would be good to include in the instruction sheet.