News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Honing wheel

Started by Lennart Bossér, January 13, 2025, 08:40:09 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Lennart Bossér

January 13, 2025, 08:40:09 PM
Hi!
Someone has used our honing wheel (Tormek T8 Black) in counter grinding mode causing an ugly scratch, but not very deep. Is there any way to restore it? Eg. bý sanding it down?

Best regards,
Lennart
Print
Go Up Pages1
User actions