News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

KS-123 For Chisels

Started by Huang, October 04, 2024, 05:45:46 AM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

tgbto

#15
October 11, 2024, 08:23:52 AM
Quote from: John Hancock Sr on October 11, 2024, 02:57:42 AM
Quote from: tgbto on October 04, 2024, 03:04:11 PMSo you'd have to measure the protrusion distance ...

Even then it would not be accurate since the jig is specifically designed to use with the knife jigs which center lines are sitting a specific distance above the bar. I have not checked but if the Square Edge jig is a different distance above the bar then the geometry will be out.

Correct ! My bad.
Print
Go Up Pages 1 2
User actions