News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

T-4 with a 210mm wheel...

Started by cbwx34, April 06, 2023, 10:11:16 PM

Previous topic - Next topic

cbwx34

T-4 with a 210mm wheel installed...

You cannot view this attachment.

... only "mod" was to put a small block under the water trough to raise it up.  (I also put a piece a tape on it so it wouldn't move around during use.)

Only downside is the stone has to be removed to install/remove the water trough.

Sharpened a couple of knives, didn't see any issues. (You might need the longer USB for some knives?)

(Do I have hard water?)  ::)

Edit:  Thought I'd add a link to another post where a SG-250 wheel was put on a T-4...
https://forum.tormek.com/index.php/topic,3344.msg20259.html#msg20259
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

TireguyfromMA

Hmmm...interesting. There's a used market, or at least a second life for the 250mm wheels after they get to small for the T8.