Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Sir Amwell, November 06, 2022, 10:02:50 PM
Quote from: Sir Amwell on November 07, 2022, 12:15:08 AMYes I have the manual and studied it. Can't find anything I find relevant to squaring the edge. Stuff about the 2 micro adjusts for cambered edges.....
Quote from: Ken S on November 07, 2022, 03:39:23 AMI find the coverage of the adjustment knobs in the handbook unfortunate. The emphasis should be on cambering planes, not on aligning chisels. The SE-77 is a major advance for cambering plane blades. Being able to control camber with bench planes is one of the things which distinguishes a cabinetmaker from a woodworker. The amount of camber sets the cut depth of a planes which varies according to the function of the plane.Ken
Page created in 0.019 seconds with 20 queries.