News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Question on Vintage Tin Snips

Started by Rimu, October 01, 2022, 06:48:55 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Rimu

October 01, 2022, 06:48:55 AM
I have an old pair of tin snips that I have got very sharp on the Tormek, but these seems to be an issue that they cut great down by the tips, but as the material moves closer to the pivot point, it cuts less and less...

It this an issue with the sharpening or more likely are the blades bent and just not meshing properly? (the photo is an example of what they look like... not the actual tool...)

RichColvin

#1
October 03, 2022, 04:38:43 AM
I have those same ones and I would try the scissors jig (SVX-150).
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.

RickKrung

#2
October 03, 2022, 02:09:05 PM
Perhaps they are not tight enough to engage properly near the pivot point.  Is the pivot pin adjustable?  I looked online for some info and found a photo of a pair that show a hex nut on one side, suggesting the pin is threaded.  Maybe you can tighten them to see if that helps. 

Rick
Quality is like buying oats.  If you want nice, clean, fresh oats, you must pay a fair price. However, if you can be satisfied with oats that have already been through the horse, that comes at a lower price.

BeSharp

#3
October 03, 2022, 05:51:14 PM
Tighten the bolt and nut so that the jaws stop from just gravity about halfway.
Print
Go Up Pages1
User actions