News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharpening an Ulu?

Started by John ~ LolliPop Farm, September 04, 2022, 10:45:46 PM

Previous topic - Next topic

John ~ LolliPop Farm

Got a job in that had befuddled me as to how to jig this up, any ideas vs freehand?

V/r
John G.

Sir Amwell

Hmmm. Tricky. I'm assuming the blade is not detachable from the handle? And that the tape and towel in the photo is hiding the handle?
I think it is a freehand sharpening job.
Or you could use a WSKO with blade grinding attachment, very carefully?

Sir Amwell

Also, from the photo, it looks like a convex primary bevel with a secondary bevel. Even if you could get a jig on it to enable using a Tormek you would have to be careful to only work on the bevel at the very edge, if that makes sense?

cbwx34

Quote from: John ~ LolliPop Farm on September 04, 2022, 10:45:46 PM
Got a job in that had befuddled me as to how to jig this up, any ideas vs freehand?

Some ideas from another thread...

https://forum.tormek.com/index.php?topic=3896.0
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

GeoBoy


3D Anvil


cbwx34

Quote from: GeoBoy on September 05, 2022, 03:57:42 PM
Wouldn't the axe jig work?

I tried it... with some modifications, you probably could, but I couldn't figure one out at the time.
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

capt rich

Sissor jig base with a block the width of the blade to top of handle [ shim ]. Ax jig same way