New DF-250 has small voids

[lady_shock]

I recently purchased a DF-250 (fine) specifically to use the side of the wheel to make chisels and plane irons flat.
New out of the box, I notice small voids on the side where it appears the diamond layer did not adhere or maybe chipped away.
My intuition tells me this should be ok as there will be only a small sector of each revolution of the wheel were no grinding occurs, but I'm really obsessive about sharpening and can't shake the feeling that this isn't good and I should return the wheel before I use it.
Any thoughts and experience would be much appreciated!

[cbwx34]

I recently purchased a DF-250 (fine) specifically to use the side of the wheel to make chisels and plane irons flat.
New out of the box, I notice small voids on the side where it appears the diamond layer did not adhere or maybe chipped away.
My intuition tells me this should be ok as there will be only a small sector of each revolution of the wheel were no grinding occurs, but I'm really obsessive about sharpening and can't shake the feeling that this isn't good and I should return the wheel before I use it.
Any thoughts and experience would be much appreciated!

I don't see that on the wheel I have.  I would probably email Tormek Support, and ask them.

[Ken S]

Welcome to the forum, Lady Shock.

My first thought in situations like this is to refer you to Tormek support (support@tormek.se). Plan "B" would be to contact your dealer. Send the photo you posted.
Keep us posted.

Ken

[RickKrung]

One of my diamond wheels developed what I called a "chip".  I contacted Tormek support.  They basically said "no big deal".  That was several years ago and it has not proven to be any problem, I've essentially forgotten about it. 

Good luck.

Rick