tormek supergrind 2000

[Mathey]

hello and thank you for the add.  just got a supergrind 2000 with a bunch of jigs and a stone grading tool.  it has been in storage for 12+ years.  is there any maintenance i need to do to it before i get started?  motor, grinding wheel, leather wheel? how do i determine the stone is "True".  it appears to have very little use. 
thank you for your time.
Mike

[cbwx34]

hello and thank you for the add.  just got a supergrind 2000 with a bunch of jigs and a stone grading tool.  it has been in storage for 12+ years.  is there any maintenance i need to do to it before i get started?  motor, grinding wheel, leather wheel? how do i determine the stone is "True".  it appears to have very little use. 
thank you for your time.
Mike

Here's a bit from Tormek's website to get you started...

Tormek machines are pretty much maintenance-free, but there are a few things you can do.

Check the main shaft yearly and make sure it has grease on it.
Check the nylon bushings, they should have lubricant on them.
Use white oil or light machine oil on the honing wheel to keep it soft and efficient.
After each sharpening session, lower the water trough (or the small steel particles from sharpening might stain the grindstone).

https://www.tormek.com/international/en/contact-support/frequently-asked-questions/maintenance/

and the online manual if you don't have one...

https://www.tormek.com/international/en/my-tormek/handbook/

[Mathey]

Thank you

[RichColvin]

Mike,

Here is what I've compiled:  https://sharpeninghandbook.info/indexTormekMaintenance.html. 

By the way, I too have a Tormek 2000. 

Kind regards,
Rich

[Mathey]

Thank you. Going to go through it this weekend. I did order the micro adjust bar and the new version of the truing tool