News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Using TORMEK for flat sharpening

Started by Arthur, March 21, 2021, 07:36:32 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Arthur

March 21, 2021, 07:36:32 PM
TORMEK adaptation for flat sharpening

sharpening_weasel

#1
March 26, 2021, 01:27:30 AM
Very interesting! What stone is that? How would one go about truing it?

Arthur

#2
March 28, 2021, 01:12:29 PM
Quote from: sharpening_by_jesse on March 26, 2021, 01:27:30 AM
Very interesting! What stone is that? How would one go about truing it?
In the photos above the stone for MAKITA 9820.

Arthur

#3
March 28, 2021, 01:22:14 PM
After receiving two sets of MB-100, the possibilities of TORMEK have significantly expanded and I am happy to use my T-4 for flat grinding.
Also after appropriate preparation (organization of the working area), I use any stones for flat grinding.

micha

#4
March 28, 2021, 06:50:29 PM
What a sophisticated approach!

I would have been concerned about the cascaded MB-100s being not sturdy enough, interesting to hear that you don't have problems with that setup.
Thanks for sharing,

Mike
Print
Go Up Pages1
User actions