News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

SVD-110

Started by Ken S, September 24, 2020, 02:12:59 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Ken S

September 24, 2020, 02:12:59 AM
My new SVD-110 Tool Rest arrived today. I have lost count; this is the fifth or sixth I have purchased. Previous ones have ended up cut into pieces to become small platform jigs. A friend just gave me a small platform jig based on the SVS-150 Scissors Jig.

As much as I like the small platform jigs, I have also been wanting a full size, standard issue Tormek SVD-110 Tool Rest.It works well for larger projects, such as turning scrapers and skews. That was its original purpose. I plan to keep this Tool Rest far away from my bandsaw.

Ken

RichColvin

#1
September 24, 2020, 04:53:51 AM
I have 2, and use them often.  Sometimes, I use two together (had to bandsaw a bit off one to do that).
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.

cbwx34

#2
September 24, 2020, 05:14:35 AM
I once used the SVD to make an FVB...



;D  ;D
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

Ken S

#3
September 25, 2020, 12:34:59 PM
Clever idea, CB.

Ken

cbwx34

#4
September 25, 2020, 02:47:48 PM
Quote from: Ken S on September 25, 2020, 12:34:59 PM
Clever idea, CB.

Ken

Have I ever had a bad one? ;)

Kidding of course... 8)
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

Ken S

#5
September 25, 2020, 04:54:33 PM
Not yet; however, as Curly would say...........

          "Day ain't over"

:D

Ken

cbwx34

#6
September 26, 2020, 05:21:40 PM
Quote from: Ken S on September 25, 2020, 04:54:33 PM
Not yet; however, as Curly would say...........

          "Day ain't over"

:D

Ken

It's why I didn't post the rest of the day...  ;)
Knife Sharpening Angle Calculator:
Calcapp Calculator-works on any platform.
(or Click HERE to see other calculators available)

Ken S

#7
September 26, 2020, 06:31:44 PM
Good one, CB!   :)

Ken
Print
Go Up Pages1
User actions