News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Settings for 40 degree fingernail spindle gouge

Started by dcwood, December 23, 2014, 06:53:15 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

dcwood

December 23, 2014, 06:53:15 PM
Hi. I would appreciate any guidance on what the settings would be for a 40 degree angle on a fingernail spindle gouge.  Would it be the same as the bowl gouge settings in the examples shown in the manual? Thanks DC
Print
Go Up Pages1
User actions