inspired by Ionut and Herman

[Ken S]

Herman,

Having the bolt go through a slot instead of a round hole would allow the table to be lengthened or shortened as needed.  (Total length would remain constant.  The only change would be in the projected length toward the wheel.)  Even if the final jig had just a hole (or a couple of holes for some adjustment), having a prototype with a slot would give a good feel for what projected length worked well.

Ken

[Herman Trivilino]

I was thinking of the slot, or perhaps a series of holes.  I may make a wooden prototype.

Made a video of myself using the jig this morning.  It's just under 10 minutes.  Having trouble uploading to photobucket so I'm trying youtube.  It takes a long time to upload!