News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Ionut's Small Knife Jig

Started by Herman Trivilino, March 10, 2013, 09:13:50 PM

Previous topic - Next topic

Herman Trivilino

Also, if you plan to sharpen small edge angles, you will need to bevel the underside of the platform where it meets the grindstone. You may find that your platform flexes because it is too thin.

I'm delighted that all these years later people are still making this jig and watching my YouTube video.
Origin: Big Bang

CopperFish

The screws are far enough back they don't get in the way of my blade. I followed your guidance on the forum or in your video? and beveled the back side of the plate. The big mistake I made was centering the diving board. I'm going to use this one for the buffing wheel and make another one that is left justified for the grind wheel.