News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Out of round

Started by Byron, March 10, 2005, 01:30:59 PM

Previous topic - Next topic

Byron

Jeff,
My system is about one week old.  I have sharpened about three pair sicssors and four chisles.  I noticed yesterday that that the stone is out of round.  I determined this by moving the tool rest close to the wheel and turned it.  It does have a high spot.  Is this normal so soon? ???