News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Square Edge jig

Started by Tony29, May 22, 2010, 12:36:10 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Tony29

May 22, 2010, 12:36:10 AM
I've had issues getting square grinds on my chisels using the SVH-60 jig, even when following the tech bulletin on properly tightening the jig.  Is there any advantage to using the SE-76 Square Edge Jig?

Jeff Farris

#1
May 22, 2010, 03:07:10 PM Last Edit: January 24, 2017, 07:25:35 AM by admin
Tony,

The SE-76 has several distinct advantages over the SVH-60.  Here's a link to an explanation and the instructions for the jig.

http://tormek.com/media/448712/hb-10-en-v101-se-76.pdf
Jeff Farris
Print
Go Up Pages1
User actions