News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharp and matched!

Started by bnlsrv, May 13, 2004, 01:32:44 AM

Previous topic - Next topic

bnlsrv

Well, after speaking with Jeff, I was able to get those planer blades matched. Very little wave - near perfect. I guess the problem was not keeping my hands over the wheel while grinding. Also, very little uneven wear on the stone - though still more on the hone wheel side. I also trued the wheel a little different this time - didn't try to compensate for the slant on the universal support. One other thing was removing the pin on the blade holder so that I could get as much overlap as possible on my 13 in blades.
I think next time I can nail this in a timely manner.
I also think Jeff should write his own book on how to do this stuff- he's got a lot of know how and experience. :)
Bill in the midwest.