News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Meat slicer blade sharpening

Started by Joe_G, December 03, 2008, 09:11:18 PM

Previous topic - Next topic

Joe_G

Has anyone tried sharpening a meat slicer blade? The blade on my slicer is about 9 inches in diameter with about a 1" center hole. The edge is angled from one side only. I think the T3 should be able to do this but I'm wondering about a fixture and blade rotation during sharpening/honing.

If I need to make a fixture, would I grind/hone this round blade on the diameter or the tangent?

Jeff Farris

I don't often recommend this, but I think this may be a job better left to professionals.  Check with the manufacturer and see what they recommend.
Jeff Farris