News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

3D printed pre USB setup

Started by Nik3, Yesterday at 12:40:56 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Nik3

Yesterday at 12:40:56 PM
Good day gentleman and ladies!

After getting back to sharpening again after my first kids (twins)

I started thinking.
3D printed pre USB setup, anybody tried it?

I have my first test now for the fvb with standard project distance 130-140-150 and DPS at 15. For the Tormek leather wheel.

Please come with critic so we can evolve together!

Best regards
Niklas
Print
Go Up Pages1
User actions