News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

Chainsaw bar dressing?

Started by Rimu, November 19, 2023, 10:01:24 AM

Previous topic - Next topic

Rimu

Anyone here ever used a Tormek to dress a chainsaw bar? If so, how?

John Hancock Sr

No - you could but I find it infinitely easier by hand. I use a mill file (single cut). I place the bar in a vice, I place the file at right angles to the bar and draw the file along the bar. It only takes a few strokes to bring it up to scratch. You can also buy bar dressing jigs, including a file that keeps the file at right angles for a few $$.

https://www.ebay.com.au/itm/134783005426?hash=item1f61b172f2:g:-h4AAOSwntVlJPcn&amdata=enc%3AAQAIAAAA0BOzzSw%2BAU5wBOOPkIWRWaSOBVvGu%2BoDvj14qPR4MF2dycC90mmisnWUxvEhvR6SJJ%2BbK16JAKGEWKU5Bo2puAdoa%2BbjbxSK9wCZbA6t6o%2F%2Ff5%2FY%2FtncVgMP8zGZPUQOz3FegmUrbQPN%2BayJL3VIHloKKvNUn5t7y4jLKWTuDWBl%2BKINBXMgNrG8IO%2F8ddGr8mBmZ6W9SUM1eRD7%2BJtoSudc%2FwMGAeFKihjlr5FqPp%2BRzPwbKNV0Q8HHeohXF2jZOQxSEuJ8REcTizeO3i8HzBY%3D%7Ctkp%3ABk9SR7KqvZ39Yg

If I were to use the Tormek I would use the SVD-110 set it at right angles to the wheel and draw it across the wheel. Make sure that the bar is super clean, you would not want to contaminate the wheel.

Ken S

I agree with John. There are more practical ways to sharpen a chainsaw than by using a Tormek. There has been messages stated or implied that "a Tormek can sharpen any edge in the house". While this is mostly true, the Tormek is not always the best or most practical choice. For jobs like chainsaws, hand files are hard to beat. A well chosen set of hand files will be handy for many jobs and will often do the job more quickly than setting up a power tool.

Ken