Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Dr.Al, July 25, 2023, 05:34:32 PM
Quote from: JohnHancock on September 15, 2023, 01:02:38 AMGenius of you don't mind me saying. My son has a 3D printer and he whipped up these for me, as well as the screw knob you referenced. I had to get the heat nuts which came earlier this week. I bought a kit of heat nuts, well two kits, one for my son. It worked as advertised and produced a perfect edge. The router was an old Stanley from about 1910 and belonged to my dad an has his initials on a knob. I am guessing that he bought it new when he was an apprentice. I am so pleased that the blade is now looking as new thanks to your jig.
Page created in 0.036 seconds with 20 queries.