News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Using the WM-200 Angle Master for Knives

Started by SparkyLB, January 17, 2022, 05:42:35 PM

Previous topic - Next topic

austijp

I'm glad this topic has been brought up, it has bothered me since day one, I found it very difficult to measure the primary angle on a blade so I could make the needed angle calculation and adjustment.  I started out using the black felt marker because I didn't trust the gauge, but that didn't work on the knives that were abused.  Now I use software and I am so happy with the results.  I think the Tormek gauge definitely has a place especially with square tools like chisels, but for tapered blades like knives I am totally sold on the software path.