News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Delta 12 1/2 " planer blades

Started by Chrit, February 10, 2008, 08:28:58 PM

Previous topic - Next topic

Chrit

I have a Delta 12 1/2" planer and I talked to Jeff at The tool Show in Novi Mi. After I explaned the I couldn't grind my blades on a Tormex grinder, jeff Told me to pull the roll pin out of the fixture. This solves all the problem for length grinding. Perhaps we should listen to Jeff a bit more.  This saves me about $200 / year on blades. Thanks Jeff :)
Chris Potts
Potts Woodworking