Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by RodC, January 23, 2023, 06:30:56 AM
Quote from: RodC on January 23, 2023, 06:35:36 PMThanks guys for the replies. I am using the SG-200 stone. One thing that I just thought of - the T-4 water trough does not have a magnet to collect the swarf. Apparently the T-8's does. That could be an issue, and I can easily address that. Looking over past posts, it looks like a 3/4" super magnet glued to the outside back vertical wall would help with this issue. Easy enough to try. I'll probably tape it on at first, then maybe use "Goop" as one post suggested....snap...
Quote from: RLGL on January 27, 2023, 02:30:45 AMRegarding the magnet for a T-4, I 3Dprinted a tab that hangs on the end of the water trough and used super glue to fasten a rare earth magnet in a recess. Quick and dirty way to solve the issue.
Page created in 0.039 seconds with 20 queries.