Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Ken S, November 29, 2022, 05:44:44 PM
Quote from: Sir Amwell on December 01, 2022, 12:26:16 AM... snipI appreciate previous comments but there is a glaringly obvious issue here. And we Let's challenge Tormek to do the right thing and produce a self centring jig with the ability to adjust the stop. It isn't rocket science surely?
Quote from: tgbto on December 01, 2022, 12:12:50 PM... snipso why bother ?
Quote from: 3D Anvil on December 02, 2022, 06:51:31 PMIt appears that the latter option is being used by AMK with their sharpening-centric 1x30 belt grinder: https://amktactical.com/AMK-75-1x30-Knife-Sharpener I imagine that their clamp could be used with Tormek, but I don't see it listed as a separate item. I'd also like to see a wider stop collar.
Page created in 0.051 seconds with 20 queries.