Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by dgendrud, November 21, 2022, 08:27:18 PM
Quote from: dgendrud on November 21, 2022, 08:27:18 PMHello,I have a Frontal Vertical Base from Knifegrinders, but have lost the angle setting software for it due to a Windows OS update. I have not been able to get a response from knifegrinders after trying their support email several times. They confirm receiving my support request every time, but never respond with how to get another copy of the angle setting software. Is there any source for downloading this software? Just hoping someone here can help with this.Regards,Doug EndrudPrescott, AZ
Page created in 0.025 seconds with 18 queries.