Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Michael Hawkins, October 31, 2022, 10:44:59 AM
Quote from: TireguyfromMA on December 03, 2022, 07:49:57 AM...snip...When I contacted TORMEK about my very noisy water tray, even sent them a video, they asked me to ship my TORMEK back to them for evaluation before they could take any action. A very reasonable request but I'd have to shut down my sharpening for a couple weeks before I got my repaired T8 back, or a replacement.. . I put a small piece of piece of electrical tape on the bottom of the tray on each side where the little lift arms contact the tray and then another strip along each side of the vertical lift slot. The tape had just the right amount of density to totally isolate the contact vibration that was going on. That was more than a month ago and it's still working great, not a peep out of it.
Page created in 0.044 seconds with 19 queries.