Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Thy Will Be Done, October 30, 2022, 12:36:18 AM
Quote from: Sir Amwell on October 30, 2022, 02:23:38 PMThe other option is to use the new KJ jig and make a portion of the knife spine ' non tapered' by using layers of tape just down from the spine where the jig bites. ...
Quote from: cbwx34 on October 30, 2022, 03:48:04 PMQuote from: Sir Amwell on October 30, 2022, 02:23:38 PMThe other option is to use the new KJ jig and make a portion of the knife spine ' non tapered' by using layers of tape just down from the spine where the jig bites. ...This was my thought... just shim the knife a bit so it's not as tapered.Just about any solution will need some adjustment. I've tried what was in the original post, (adjusting every time you switch sides) it can be done, but it's a pain, easy to lose track, and I like to do alternating passes at the end, so it's not the best option for me.Someone in the forum made a sleeve that was thicker on one side, that slid onto the SVM jig, so that when you flipped the knife over, it stayed the same. (Can't find the thread...) Found a couple... https://forum.tormek.com/index.php?topic=3918.0https://forum.tormek.com/index.php/topic,4868Schleifjunkies clamp may work (never tried one), but the sides don't taper, so you'll probably have to adjust for that.A Lansky clamp works pretty well...https://forum.tormek.com/index.php?topic=3792.0https://forum.tormek.com/index.php?topic=3834You could also try a Platform Jig... https://forum.tormek.com/index.php/topic,3818
Quote from: Thy Will Be Done on October 30, 2022, 07:59:23 PMSo is my idea correct in that what is ultimately causing the assymetric bevels mainly is a function of slight changes in degree setting of the knife as you go from side to side? If that is the case I just got the SVM-45 and will give it a go and see how it works on one of my chunky chopper blades and hopefully proof that concept works.
Page created in 0.086 seconds with 19 queries.