News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Custom drip guard

Started by Dougie, October 05, 2022, 12:48:44 AM

Previous topic - Next topic

Dougie

I want to share pictures of a drip guard I just finished for my T-8.  I love the machine, my only complaint about it is that wide blades tend to cause water to run off the edge onto the machine housing, and then on to the benchtop.  This drip guard sits very close to the stone (less than 1/16") so any water gets wicked back to the basin. 

Tormek: PM me if you want the patent rights  ;) ;D

tgbto

Woah, that's really nice looking. Did you machine it out of solid copper ?

WimSpi

That's nicely made. good idea!

Dougie

It's just thin copper sheet and brass tubes soldered together.  I cut the parts out with a jeweler's saw.  It bolts down in place of the handle, but with a little more work another handle could be added.