Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by SRT.cni, August 14, 2022, 09:53:53 PM
Quote from: SRT.cni on August 14, 2022, 09:53:53 PMHi All out there.I just thought I would put my nose into the forum.On my old m/c I decided to make a modification by making a new stainless steel main shaft no more rust problems changing the wheel ( annealed 440C )to carry the wheels and instead of having the leather honing wheel on it both ends can carry a regular or diamond wheel. Now I have a 300 grit CBN wheel on one end and a 1200 grit cbn wheel on the other. So far I am well pleased with the new setup as the 1200 grit wheel is almost as good as the leather one but then times quicker.Your thoughts on this. I only sharpen my knives and chisels etc no business involvement.
Page created in 0.042 seconds with 18 queries.