News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

Question about honing an Ellsworth shaped bowl gouge

Started by Tlytle25465, May 10, 2022, 10:04:18 PM

Previous topic - Next topic

Tlytle25465

Trying to sharpen and hone my Ellsworth shapes 1/2" bowl gouge with my new Tormek T-8 and the tool does not line up with the honing wheel.   
The set up is JS = 6, P = 65 & Hole A on the jig

Here is how things line up.  Should I just hone by hand or am I missing something?

RichColvin

I hone by hand.  Be sure to hone the flute also.
---------------------------
Rich Colvin
www.SharpeningHandbook.info - a reference guide for sharpening

You are born weak & frail, and you die weak & frail.  What you do between those is up to you.

Ken S

Welcome to the forum, Tom.

When I read your post, your Projection setting didn't look right. I thought it should be 75mm. Ifound a Nick Agar video. Here is the link:

https://youtu.be/JMzNN_IMhUE

At around two minutes, Nick explains the Ellsworth set up with the Tormek. Your A and jig setting 6 are correct. Your Projection should be 75 mm.

I don't seem to be able to locate my source video; however, I recall a suggestion (I think by Glenn Lucas) to set the TTS-100 for honing and then raise the microadjust one turn. This lets the honing concentrate on just the cutting apex of the edge.
EDIT: I found the source. It is the Tormek Basic Honing Online Class with S├ębastien and Wolfgang, starting at around 51 minutes.........

Here is a link to a good Glenn Lucas video:

https://youtu.be/-cEXDssipig

Keep us posted.

Ken