Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by RLGL, April 30, 2022, 04:04:56 PM
Quote from: RLGL on April 30, 2022, 04:04:56 PMIs there a source in the US for the FVB?
Quote from: 3D Anvil on May 01, 2022, 10:36:04 PMNewbie question: is the main advantage of the FVB that it allows the same operation when sharpening away from the edge as you get sharpening into the edge? Or are people using it for honing? Because it seems to me that honing would still have the problem of the grinding wheel getting in the way, no?
Quote from: dec11ad on May 05, 2022, 11:59:09 PMJust finished fabricating my own FVB. Now all that's left is to test and find an angle calculator that will work with it..
Page created in 0.036 seconds with 20 queries.