Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Rbodger, May 23, 2022, 02:01:25 PM
Quote from: Rbodger on May 23, 2022, 02:01:25 PMI've had my Tormek since 1995 or so. Has anyone figured out how to freehand grind on the platform in the horizontal position on the vertical side so the wheel is pulling the tool down? I can't do a 40 40 grind on the horizontal side because it pulls the tool up onto the wheel. Maybe drill holes in the vertical supports? Holding a turning tool vertically is pretty awkward.
Page created in 0.029 seconds with 20 queries.