News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

A DIY 1,500 Watt Power Station for My Sharpening Business

Started by BeSharp, October 15, 2021, 10:30:57 PM

Previous topic - Next topic

BeSharp

I built a 1,500 Watt power station for sharpening at farmers' market and other places with no power.

All my equipment fits into Tanos / Festool Systainers. Therefore, I wanted my power station to be inside a Systainer too!

Festool just introduced their SYS-PowerStation, but 1) it's not in North America yet, 2) It's 2,610 Euros / $3,750 CAD / $3,030 USD, 3) I don't need that much power, since a Tormek only uses 200 Watts, a Twice-As-Sharp scissors sharpener uses 375 Watts, and my Rikon buffer, 300 Watts (and I hardly use more than one machine on at a time).


BeSharp

The 6' back table is for a Viel S-5 at one end, and a Twice As Sharp scissors sharpener at the other end. In the middle is this Tanos / Festool Systainer stack:

Top: Toolbox M137: holds Tormek jigs, tape, knife sleeves
Middle: 3-drawers: holds tools, abrasives, lubricants, sharpness tester, etc.
Bottom: the DIY power station

BeSharp

Closeup and inside pics:

Total cost was $900 CAD / $ 727 USD / $627 Euros (using a half-price used battery) Battery capacity is 840 Watt-Hours; 120 VAC power output is 1,500 Watts. It weighs 8.3 kg / 16 lbs 6 oz.

More pics and deeper description at my post on FOG (Festool Owners' Group) forum: https://www.festoolownersgroup.com/festool-and-tanos-systainers/a-diy-1-500-watt-systainer-power-station/

BeSharp

How Long Will It Run?

A Tormek uses 200 Watts of power; the Rikon buffer uses 300 Watts.  It takes me about 7 minutes to sharpen a knife, of which actual machine "on" time is probably 5 minutes. 5/60 x 250W (average) = 20.8 Watts/knife.

Trials confirm this - a knife takes roughly 20 Watts.

At a farmer's market a lot of time is spent interfacing with customers, so in reality only 6 knives/hour, or 120 Watt-hours.

A 4-hour market then uses 4 x 120 = 480 W-h.

My battery is 840 W-h. However, I only charge it to 80% capacity and try not to discharge it below 20% (it triples the battery life). Therefore, 840 W-h x .6 = 504 W-h of usable energy.

In conclusion, the 840 W-h battery has enough capacity for a 4-hour market.


Ken S