News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Aus 10 steel

Started by Sir Amwell, August 28, 2021, 04:29:53 PM

Previous topic - Next topic

Sir Amwell

Was wondering if anyone is familiar with this steel?
If yes, was also wondering what sort of burr it produces? - positive,negative or intermediate?
Thanks.

BradGE

I don't have experience with AUS10, but in the absence of a definitive answer from someone else here I would probably start with the assumption it's positive and see if the results prove or disprove that...

Ken S

Welcome to the forum, Simon.

Vadim Kriachuk of Knife Grinders (knifegrinders.aus) wrote the book on deburring. Like many of our members, I have known and liked his for years. Send him an email. He is the most knowledgeable source I know of.

Ken

Sir Amwell


BeSharp

According to his Deburring book, AUS-10 is "in-between:.