News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.

www.tormek.com

Main Menu

Low Cost Spacer

Started by BeSharp, October 17, 2020, 06:34:20 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

BeSharp

October 17, 2020, 06:34:20 PM Last Edit: October 17, 2020, 06:37:24 PM by BeSharp
As most regulars here know, it's best to transport Tormeks without the grinding wheel. This means a spacer is needed to hold the drive wheel and main axle in place during transport.

A plastic CPVC plumbing connector for 3/4" pipes works. It could be a little bit shorter, but I've never had one fall off. Cost me $.71 CAD ($.54 USD / .46 Euros).

Ken S

#1
October 17, 2020, 08:59:55 PM
Clever idea. A spacer is essential. Your idea seems very practical and cost effective.

Ken

jeffs55

#2
October 17, 2020, 09:25:21 PM

Offline Ken S
Moderator
Hero Member
*****
Posts: 6666

Ken!!!!!!!! You need to hurry and make another post. Too many 6s.
You can use less of more but you cannot make more of less.
Print
Go Up Pages1
User actions