Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by emlclcy, July 29, 2020, 10:25:10 AM
Quote from: RickKrung on July 30, 2020, 03:08:08 PM too narrow to sharpen
Quote from: emlclcy on July 31, 2020, 11:47:44 AMi have a milling machine and ran a dial gauge along both the sliding extrusion and the fixed steel part and they are both not exactly flat so maybe the combination of two errors and the blade at a shallow angle will cause this error. i'm going to take a very light cut off both parts where the plastic strip was glued and try againregardscarl
Page created in 0.042 seconds with 19 queries.