Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by klipsch21, December 06, 2019, 03:43:59 PM
Quote from: Ken S on January 13, 2020, 07:44:09 PMGood post, Rick.Ken
Quote from: RickKrung on January 13, 2020, 07:39:57 PM... If you get any caliper, make sure it operates in metric units (as well as imperial). Most have a button that switch between units. . Carry on and keep us informed of your progress and questions.Rick
Quote from: Georgie on January 19, 2020, 01:24:37 AMRick, thanks for that input. I'd simply ask what length/size caliper is going to cover the vast majority of FVB sharpening applications and measurements? Given that the 250mm wheel diam. Is part of the FVB equation I have to assume one with that minimum range.
Quote from: RickKrung on January 19, 2020, 05:57:57 AMI've also posted about using woodworking marking gauges, setting the distances using calipers, but using the marking gauge to transfer those settings to the knife jigs or USB positions. Below is a huge dump of information on the calipers and marking gauges I use for sharpening. Sorry, it is quite long, so I'll sign off before.Rick
Page created in 0.056 seconds with 20 queries.