Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by RickKrung, November 20, 2019, 08:30:09 AM
Quote from: Jan on November 20, 2019, 10:05:15 AMRick, the original SVX-150 has four springs. Two of them are lost in your case. It does not influence jig functionality because it only opens the clamp. When the blade is short it is mounted in one clamp only. See the attached picture. The bevel must be oriented towards the stone, flip your blade! The other blade will be mounted in the same clamp. Keep the blade protrusion as small as possible. Also the support plate should be mounted in the lowest possible position with respect to stone to prevent vibrations. Jan
Page created in 0.028 seconds with 19 queries.