Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by Sharpco, November 19, 2019, 06:07:34 AM
Quote from: jeffs55 on November 19, 2019, 10:43:57 AMI am going to say that the angle is too sharp, so the blade is so thin it chipped from a faulty inclusion.
Quote from: SHARPCO on November 19, 2019, 06:07:34 AMI used SG-250. The dressing is done by diamond plate(#80 >>> #400). After that, I did honing on leather wheel. But I could find chip on the edge. Could you tell me what's wrong?
Page created in 0.013 seconds with 19 queries.