News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Replacement of knob

Started by Sharpco, September 01, 2019, 07:40:52 AM

Previous topic - Next topic

Sharpco

Quote from: van on September 16, 2019, 05:33:39 PM
Maybe it will be off topic, but which sharpening angle do you use? to have this kind of problem.

It depends on width. Generally over 20 degrees.

mat450

when you flip the jig to when the knob faces down, using sharpy mark position of jig on blade, then undo jig and flip so knob is facing upwards and tighten jig same place on blade.

I do this method on thick blades to get even bevels