Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.www.tormek.com
Started by schipperke, September 07, 2019, 02:05:09 AM
Quote from: schipperke on September 07, 2019, 02:45:43 PMHell of a lot of money to be broken out of the box.
Quote from: Jan on September 07, 2019, 06:04:16 PMSeveral years ago I was analysing some motor issue. In my T7 machine there is a good quality Austrian motor produced by ATB Spielberg GmbH. I was assured that the motors are tested in Sweden before expedition. In your T4 machine there is probably a similar motor only with smaller power.The annoying sound of your T4 is a typical resonance of some component. Please try to tighten the locking screws of the sleeves for the universal support bar. Eventually check if the capacitor is firmly attached to the motor. Good luck.Jan
Quote from: jeffs55 on September 07, 2019, 08:08:29 PMThat's the problem, was shipped half way across the country You're not in Belgium are you? Halfway across the country is like the next town over in the US.
Quote from: Roger M. on September 08, 2019, 03:25:21 AMYou're definitely not alone.My T-4 ... also brand new (from Lee Valley), makes exactly the same noise.The noise "goes away" when I press a knife to the wheel, but always returns when I lift the knife away.This is really unacceptable, so begins the process of returning it.**EDIT** ... returning it for replacement that is - I think the machine is fine, I just can't stand the noise
Page created in 0.019 seconds with 20 queries.